These fit perfectly in my 2008 Jeep Wrangler JK, Sahara Unlimited. They were a little tricky to install, but that’s not any fault of the design here. The way they go in on the Jeep requires fishing the cables through a small gap behind the engine, which is tricky.A little cheat to make it easier? Use some duct tape! Tape one end of the new cables to the other end of the old cables, and then just pull them through with the old cables! Saved me a lot of time. Note that you’ll still need to free the old cables from a small mount plastic mount on the passenger side, but it’s doable. I also did have to reach behind the engine to remove an old twist tie that was there from the last time the cables were changed, but all in all the duct tape made things way easier. Just make sure to tape it really well so that the new ends don’t split from the old ends!